Bulk Discounts Available

1(800) 446-2467
Hours: 8:00am-5:00pm EST M-F

Series 1000A 7/8, S&D Drill 1/2" Shank

Series 1000A 7/8, S&D Drill 1/2" Shank

Quick Overview

Series 1000 7/8, S&D Drill 1/2" Shank, Fractional, High Speed Steel, Bright & Black, 118° Point, Reduced Shank, One per Pack
Manufacturer: Drillco
Part #: DRILLCO-1000A156
SKU: DRL1000A156
Selling Unit: Pack (1)
$19.80 / Pack (1)
Series 1000A 7/8, S&D Drill 1/2" Shank is available for purchase in increments of 1

7/8" Drillco S&D Drill Bit with 1/2" Shank

Drillco 1000A156 is a size 7/8" Silver and Deming straight shank drill designed for drilling low- and medium-tensile strength materials. The 1000A Series drill bits feature a 2.5" flute length, uncoated, with a black oxide finish that reduces wear and promotes chip and coolant flow.

1 bit per pack.

About the Drillco 1000A Silver Deming Drill Series

Silver and Deming drill bits are characterized by straight shanks that are smaller than the diameter of the bit. This 118 degree split point S and D drill bit with a straight shank of high speed steel for hardness and wear resistance. The round shank accommodates most drill chucks.

Expands the size range capacity of a 1/2" portable drill Chuck. Common flute and overall length for minimal adjustmentduring tool changes. Precision ground for a high degree of concentricity between shank and body diameter.The 118 degree split point reduces thrust and eliminates walking at the drill point.

About JAM Industrial Supply of Ohio

Locally owned and operated in Canton, OH, JAM Industrial Supply, LLC has been a 3M Premier distributor and industrial supplier for over 20 years. With our vast network of vendors, we are able to supply the industry's best products, information, delivery and prices to our customers. We carry a full line of Drillco Cutting Tools.

Part NumberDRILLCO-1000A156
Per CaseNo
Unit of MeasurePack (1)
Make to OrderNo
Body DiameterNo
D LimitsNo
Per Pack1
Cutter DiameterNo
Shank TypeNo
Depth Of CutNo
FinishBright & Black
Flute Length3 in
Flute Length MetricNo
Length Of CutNo
Length Of ThreadNo
Cutter DiameterNo
Country Of OriginUSA
Depth Of CutNo
Number Of FlutesNo
Overall Length6 in
Drill SizeNo
Flute LengthNo
Overall Length MetricNo
Flute Length MetricNo
Pitch Diameter LimitsNo
Pitch Diameter MetricNo
Large End DiameterNo
Largest DiameterNo
Shank LengthNo
Shank Size1/2 in
Length Of CutNo
Length Of ThreadNo
Shank TypeReduced Shank
Size MetricNo
Maximum SizeNo
Minimum SizeNo
Morse TaperNo
Morse Taper OutsideNo
Outer DiameterNo
Point DiameterNo
Number Of FlutesNo
Number Of StepsNo
Tool NumberNo
Pipe SizeNo
Pipe Tap CapacityNo
Pitch DiameterNo
Pitch Diameter LimitsNo
Pitch Diameter MetricNo
Reamer CapacityNo
Screw SizeNo
Shank LengthNo
Shank SizeNo
Shank Size MetricNo
Size RangeNo
Small End DiameterNo
Smallest DiameterNo
Step IncremenetsNo
Tap CapacityNo
Width A/fNo